Flemish Spiral Necklace
Cut a segment of wire 2-1/2 inches long. For your first effort use 20-gauge wire. As you become experienced you can increase your wire size to 18- or 16-gauge.
Make a loop in one end of this wire using your round-nose pliers or wire-wrapping pliers.
Straighten this wire using your nylon jaw pliers.
||Position two metal pegs and two 3/16 inch Super Pegs in your jig. Place your initial loop on peg 1 and wrap the wire around pegs 2, 3 and 4.
||Remove the wire from the jig and using your round-nose pliers or wire-wrapping pliers, complete the final loop in your wire component.
Cut the excess wire leaving this final loop open so that we can slide chain onto this wire component via this open loop.
Make a total of 5 of these components in either the size of this first one, or in the smaller size shown by peg positions 1-4S.
Cut twelve 1-inch segments of commercial chain.
Slide the end link of two segments of chain onto each of your five wire components. Position the chain so that the two chain segments are opposite one another on the wire.
Now we need to wrap fine gauge wire around the center of this wire component. First, cut 5 segments of 22- or 24-gauge wire about 2-1/2 inches long. Make a "U" shaped bend about 1/2 inch from the end of this wire. Open the inital loop in your wire component using your chain-nose pliers.
||Slide the "U" shaped bend into position at the center of your wire component and wrap the fine gauge wire around about 3 times. Hold the wire with your chain-nose pliers and squeeze the wire flat after each wrap. Cut the excess wire and tuck in the cut end.
Now connect each of these five segments of wire using a wrapped bead link. Use 22- or 24-gauge wire to make the wrapped bead link. Use another pair of wrapped bead links to connect that last two segments of wire to either end of your chain.
Now we are ready to attach our clasp. Use two more wrapped bead links to attach your clasp. Select the size of your beads for these links according to the length of necklace that you want. (In the necklace at top-right, the last two wrapped bead links used 2mm beads.)
: : : Additional Resources : : :
For more information on this pattern, please visit http://www.wigjig.com
Have a question regarding this project?
Email Customer Service.
Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction
requires written permission. Please email email@example.com
for more information.