Single-Strand Necklace with Swarovski Crystal
Due Fiore Lariat Necklace
Get inspired by Swarovski design team's limitless imagination. Magical project ideas bring a new dimension to simple techniques.
: : : Materials : : :
- Leather cord
- Pliers, flat-nose
- Please take the creative opportunity to substitute the TierraCast components shown above with alternative items offered at Fire Mountain Gems and Beads.
Fold leather cord almost in half, leaving one side about 1-1/2 inches longer than the other side.
Loop the closed end of the leather cord through the TierraCast Radiant Ring and drop the two ends through the loop that is created in the leather cord to secure the cord onto the Ring.
Cut the 24 gauge wire into three equal pieces. Connect the long cord end to the short cord end by wrapping one piece of wire around both cords about 1-1/2 inches above the short end of the cord. Wrap wire around cords several times to secure. Gently flatten wire slightly using flat-nose pliers.
Loop the long end of the leather cord through one of the open petals of the filigree from the Swarovski crystal assortment. Loop it back around and up the side of the cord about 1/4 inch. Secure the cord end to the other side of the cord by wrapping another piece of 24 gauge wire around both several times. Again, gently flatten wire slightly using flat-nose pliers.
Loop the short end of the leather cord through the TierraCast Large Quatrefoil Link and secure the cord as done in step 4.
Cut three 1.5" pieces of 20 gauge wire. Make a loop at the bottom of all three wires and add one Swarovski Bead art. 5328 5mm sand opal to each. Turn a loop at the top of each wire.
Turn a loop at the bottom of the remaining piece of wire. Add the Swarovski bead art. 5328 8mm mocca and turn a loop at the top of the bead.
Attach one 5mm sand opal beaded wire to one of the loops in the 8mm bead. Attach the loop at the top of the 8mm bead to the bottom of the Quatrefoil Link. Attach one 5mm sand opal beaded wire to both sides of the mocca bead on the Quatrefoil Link. Make sure all loops are closed securely.
Open the 8mm jumpring and attach it to one of the open petals on the other Swarovski filigree. Attach the jumpring to the Radiant Ring and close to secure.
Have a question regarding this project?
Email Customer Service.
Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction
requires written permission. Please email email@example.com
for more information.