Single-Strand Necklace with Swarovski Crystal and Satin Ribbon
Get inspired by Swarovski design team's limitless imagination. Magical project ideas bring a new dimension to simple techniques.
: : : Materials : : :
- Pearl, Swarovski crystal, dark grey, 4mm round (2 pearls)
- Pearl, Swarovski crystal, dark grey, 11x8mm pear (1 pearl)
- Pliers, flat-nose
- Pliers, round-nose
- Pliers, side-cutter
Drop, Swarovski crystal, indicolite, 40mm Helios pendant (1 drop)
Jumpring, silver, 12mm (1 jumpring)
Headpin, silver (3 headpins)
Slide one Swarovski crystal pearl article 5821 11x8mm crystal dark grey pearl onto a headpin and form a loop. Cut off excess wire.
Open a 12mm jumpring and slide on the crystal pearl headpin and one Swarovski pendant article 6040 40mm indicolite as shown in the illustrations.
Cut a flat 30cm ribbon and tie a bow around the pendant. Trim both ends to 2.5cm as shown.
Cut a 1m chain and two 1m cords, place them together and attach one side with tape. Begin braiding them together leaving 5cm at the top and bottom upbraided.
Tie a knot with both ends as indicated in the illustrations and cut off the cords and the chain using a side cutter and scissors leaving 2cm on ends.
Slide one Swarovski crystal pearl article 5810 4mm crystal dark grey pearl onto a headpin and form a loop. Repeat this step once. Attach both crystal pearl headpins onto the chain ends as shown.
||Open the 12mm jumpring that is attached to the Swarovski pendant with the bow and attach it onto center of braided cord and chain as shown in the illustrations.
: : : Additional Resources : : :
Have a question regarding this project?
Email Customer Service.
Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction
requires written permission. Please email firstname.lastname@example.org
for more information.