Single-Strand Necklace with Swarovski Crystal
Get inspired by Swarovski design team's limitless imagination. Magical project ideas bring a new dimension to simple techniques.
: : : Materials : : :
- Focal, Swarovski crystal, white opal, 39x24mm vertical galactic pendant (1 focal)
- Bead, Swarovski crystal, black diamond, 6mm round (1 bead)
- Bead, Swarovski crystal, crystal satin, 20mm faceted orchid (3 beads)
- Pliers, round-nose
- Pliers, flat-nose
- Pliers, side-cutter
Extension chain, silver, 12cm
Headpin, silver, (1 headpin)
Jumpring, silver, 6mm (1 jumpring)
Open a 12mm jumpring and slide onto it a Swarovski crystal pendant article 6906 20mm. Repeat twice.
Cut 90cm of 1.5mm leather cord and slide one Swarovski pendant article 6656 39mm white opal onto it.
Slide one of the pendants from Step 1 onto both thread ends and tie a knot.
Slide another Swarovski pendant from Step 1 onto the left thread end and again tie a knot as shown.
Slide on the last pendant from Step 1 onto the right thread end and tie a knot.
Cut 12cm of extension chain and slide it onto the right cord end approximately 25cm from the last pendant. Tie a knot to secure chain to cord. Cut off the short cord end approximately 2.5cm from the knot.
Slide one Swarovski bead article 5000 6mm black diamond onto a headpin and bend a loop, (do not close loop completely). Cut off excess wire.
Attach the beaded headpin from Step 7 onto the other end of the extension chain. Close loop to secure.
Tie the left cord end through a 6mm jumpring approximately 25cm from the last pendant on this end. Open the jumpring just enough to attach the lobster clasp and close the jumpring to secure. Cut excess cord end to 2.5cm.
: : : Additional Resources : : :
Have a question regarding this project?
Email Customer Service.
Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction
requires written permission. Please email email@example.com
for more information.