Spiral and Rivets Bracelet

Courtesy of TierraCast®

A Cuff Bracelet That is a Snap to Make
Prepare: Choose a leather bracelet blank with a Line 20 (13mm) or Line 24 (15mm) snap closure. Place one Spiral and Rivets link and two 10mm Hammertone LH spacers as desired. Mark holes. Punch 2.5mm holes at each mark.
Rivet: Insert post through hole from back of bracelet. On top place component onto post, then cap. Squeeze together to engage. Working on bench block, place concave end of rivet setter onto cap. Set with mallet.
Finish: Use epoxy or E-6000® Jewelry and Craft Adhesive to secure a Spiral or Rock and Roll Snap Cap to top of snap.

: : : Additional Resources : : :

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.