Triple-Strand Bracelet with Leather cord, D-Ring Clasp and Charms
Thread one leather strap 1 inch through one D-ring slot and fold over.
Use leather punch to make a hole through both layers of leather 1/4 inch from D-ring.
Insert rivet post through holes from the bottom. On top, place rivet cap onto post. Squeeze components together to engage.
Place bottom of post onto block. Place concave end of rivet setting tool onto cap. Strike setting tool with hammer until set.
Repeat Steps 1 - 4 with two remaining leather straps.
Braid the three straps together adding one ring at each overlapping point.
Adjust braid and D-rings to achieve desired bracelet length, allowing 1-1/4 inch for clasp. (Finished leather section should be 6 - 6 1/2 inches long).
Repeat Steps 1 - 4 with second D-ring.
String crystal bead and bead cap onto headpin and form simple loop.
Attach crystal dangle and charm to one round jumpring.
Attach the jumpring to the slot of one D-ring.
Attach second round jumpring to the large opening of the D-ring.
Use the medium oval jumpring to attach clasp bar to the round jumpring.
On back of bracelet trim leather ends 1/4 inch from rivets.
: : : Additional Resources : : :
Have a question regarding this project?
Email Customer Service.
Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction
requires written permission. Please email firstname.lastname@example.org
for more information.