Insert a piece of wire (20-24 gauge) 5 inches (12.7cm) in length through the hole in the findings form and bend the end (this helps to hold the wire firmly as you bend the wire around the pegs).
Wrap the wire around the large peg (clockwise) then slightly around the thin peg and up (clockwise) around the acrylic form.
Wrap the wire over and down the acrylic form then down the side of the triangle acrylic form then out to the right.
Use the Pusher tool on the small peg to tighten the intersection of the wire.
Cut the end of the wire as shown (it's advised to use a wire rounder on the end of the earwire to smooth out the sharp edges left by the flush-cutter). Remove the earwire and cut the ring so that it forms a complete circle.
If you desire a bead or other additional component un-bend the end of the earwire (opposite of the loop) and run the bead or other component onto the wire and re-bend into the desired shape.
Have a question regarding this project? Email Customer Service.
All works of authorship (articles, videos, tutorials and other creative works) are from the Fire Mountain Gems and Beads® Collection, and permission to copy is granted for non-commercial educational purposes only. All other reproduction requires written permission. For more information, please email copyrightpermission@firemtn.com.
This website uses cookies and other tracking technologies to ensure you get the best experience on our website. By continuing to navigate this website, you consent to the use of these technologies for the purposes described in our Privacy Policy.