1. Home
  2. Learn
  3. Categories
  4. Essential Resources
  5. Tools & Supplies
  6. Artistic Wire® Teardrop Connector Jig

Artistic Wire® Teardrop Connector Jig

Category

Instructions


Step 1
Step 1

Place the end of wire (20-24 gauge) 6'' (15cm) in length across findings form as shown, tail should only be a few millimeters off the form.

Step 2
Image

Wrap the wire (counterclockwise) around the single peg at the top, while holding the tale with your non-dominant hand, then on to the next peg.

Step 3
Image

Continue to take a single revolution with the wire around each of the pegs (counterclockwise). Then cross between the top peg and the acrylic form, but do not wrap onto the peg.

Step 4
Image

Use the included pusher tool to push the design all the way down to the surface of the finding form.

Step 5
Image

Hold the center of the connector as shown and wrap the left wire around the other wire.

Step 6
Image

Wrap the left wire a full revolution around the right wire.

Step 7
Image

Hold the top ring with chain-nose pliers as shown and wrap the other wire around the intersection until the component is secure.

Step 8
Image

Carefully cut each of the ends with a flush-cutter and tuck them in as much as possible with chain nose pliers.


Have a question regarding this project? Email Customer Service.

Copyright Permissions

All works of authorship (articles, videos, tutorials and other creative works) are from the Fire Mountain Gems and Beads® Collection, and permission to copy is granted for non-commercial educational purposes only. All other reproduction requires written permission. For more information, please email copyrightpermission@firemtn.com.