How to Use the WigJig® Spiral Maker Plus
Insert end of soft wire into starter hole and bend back at 45 degree angle.
Insert tool peg into WigJig hole and flip WigJig over for easier viewing.
Use non-dominant index finger to hold the spiral maker in place.
Use your dominant hand to wrap the wire in a small 1/4 turn movement in the desired spiral direction.
Turn spiral maker back 1/4 turn.
Continue this process until the coil reaches desired size.
Remove spiral maker tool from WigJig and slide wire spiral off tool.
Cut off center wire post with flush-cutters.
Tips: Use round-nose pliers to form a simple loop on the outside straight end of the wire to create a spiral drop.
Have a question regarding
this project? Email Customer Service.
Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email
for more information.