Jewelry-Making How-To Videos

How to Use a Jump Ring Maker

by Michelle Wood, Jewelry-Making Expert, Exclusively for Fire Mountain Gems and Beads®
D928

: : : Materials : : :

STEP 1
Select desired mandrel size and screw into tool.
STEP 2
Put 1 inch of wire through hole on tool. Bend short end of wire flat against bottom of tool.
STEP 3
Bend long end of wire flat against top of tool.
STEP 4
Wrap wire around mandrel.
STEP 5
Secure straight end of wire in vise.
STEP 6
While holding wire taut, insert finger in tool hole and turn until desired coil length is achieve.

Using flush-cutters, sever both ends of wire.

Slide coil from mandrel.

Cut coils into jumprings using flush-cutters or jeweler's saw.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Recommended Just for You