Using EUROTOOL® Four-in-One Beader's Delight Pliers
Presented by Esther, Lead Jewelry Production Specialist,
Instructions by Ian, Content Development Group, Exclusively for Fire Mountain Gems and Beads®
What can you do with the stainless steel Four-in-One Beader’s Design pliers by EUROTOOL®? Almost everything you can with a whole set of jewelry pliers. Jewelry designer Esther Pollock shows how to use these multi-purpose pliers that feature a long nose, flat jaw, groove and side cutter.
Place the end of a length of wire into the groove of the pliers.
Firmly hold the pliers and twist them away from yourself until the wire is bent flush against the pliers at a 90-degree angle. Release the wire then replace, grabbing just below the new 90-degree angle.
Repeat until a square is formed then trim the excess wire using the side-cutter.
Place the end of a length of wire between the ends of the rounded tips of the pliers.
Firmly hold the pliers and twist them away from yourself to create a small loop. Grab the loop with the flat jaws, holding the wire at a 90-degree angle in relation to the pliers. Bend the wire up toward the tip of the pliers. Release and repeat until the spiral is the desired width.
Place the opposite end of the wire between the ends of the rounded tips of the pliers. Firmly hold the pliers and twist them away from yourself to create a small loop. Trim excess wire.
Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email firstname.lastname@example.org for more information.