How To Use The EUROTOOL® Stamp Holder

Presented by Chris, Photography Group,
Instructions by Rachel, Content Development Group, Exclusively for Fire Mountain Gems and Beads®
H40B

Get precise stampings without worrying about your fingers getting in the way. See how the EUROTOOL stamp holder keeps everything in place for stamped jewelry designs. The EUROTOOL® stamp holder accommodates square stamp shafts up to 7mm (1/4 inch) and round stamp shafts up to 8mm (5/16 inch).
STEP 1
Insert the desired stamp into the round hole of the stamp holder.
STEP 2
Secure the stamp in place by turning the handle to tighten it.
STEP 3
Position the stamp in the desired area and use a hammer to strike the end of the stamp with a hammer in a single blow, to transfer the design.

: : : Additional Resources : : :


Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Recommended Just for You