Home
Winter Clearance Sale

Artistic Wire® Round Connector Jig

Courtesy of Beadalon®
E94Y
STEP 1
Place Wire Across Finding Form Place the end of wire (20-24 gauge) 6'' (15cm) in length across findings form as shown, tail should only be a few millimeters off the form.
STEP 2
Wrap Wire Around Single Peg Wrap the wire (counterclockwise) around the single peg at the top, while holding the tail with your non dominant hand, then on to the next peg (counterclockwise).
STEP 3
Wrap Wire Around Each Peg Continue to take a single revolution with the wire around each of the pegs (counterclockwise).
STEP 4
Continue to Wrap Wire Around Form Once all pegs are wrapped, continue around the form, but do not wrap second wire onto the top peg.
STEP 5
Push Design Down the Surface of Form Use the included pusher tool to push the design all the way down to the surface of the finding form.
STEP 6
Trim Wire Remove the connector from the form and trim both tail wires to about 1-1/4'' (3.2cm).
STEP 7
Wrap Tail of Wire Around Top Portion of Connector Grasp the right facing tail wire and wrap it tightly around the right top portion of the round connector as shown. This will take some practice.
STEP 8
Wrap Second Tail of Wire Around Top Portion of Connector Flip the finding and wrap the other tail around the top of the other side. Make these wraps as close to a mirror image as possible.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.


Sign Up for Email Specials and Beading News
Sign Up
for Email Specials and Beading News