Topics: Friendly Plastic, Finishing

I would like to try the friendly plastic and was wondering if I make some dangles for earrings would you recommend using grommets to finish the holes?
- Peterson
Adding grommets will not only finish the hole and give a professional look to your design it will also extend the wear that you might find occurs over time.

A light coating of two-part epoxy tested best when adding grommets to Friendly PlasticĀ®. Dip one grommet into prepared epoxy, wait about one minute then place the grommet into one side of the hole. Repeat adding a second grommet to the other side of the bead hole.

- Jamie Smedley, Jewelry-Making Expert

Materials Resources

Still can't find what you're looking for? Submit your Question.